Welcome: Huimin Zhongxu Screen Co., Ltd.
Language: Chinese ∷  English

Company new

Manganese steel screen installation and commissioning need to pay attention to the following points!


There are many factors related to the life cycle of manganese steel screen: product quality, screening materials, screening environment, etc. in fact, an important factor has been ignored by many customers, that is the installation and commissioning of manganese steel screen. Some students have done the operation. Is it standardized? are you ready?
1. Screen frame adjustment
Whenever the manganese steel screen is used, the screen frame should be adjusted timely and effectively after a period of working time or when the screen is replaced. The screen frame is an important bracket for placing the manganese steel screen, and it also plays a role of fixed assets for the manganese steel screen. When adjusting, pay attention to pull out the bolt first; Then you can turn the hand wheel to adjust the control device to move up and down; When it is adjusted to the required inclination angle, insert the bolt to make it have a good fixed position. Note that this process must make the bolt force, otherwise it is easy to cause internal screw force and bending damage. In addition to the adjustment process, when it is found that the exposed surface of the adjustment equipment moves, in order to avoid rust, grease coating can be added.
2. Standardized removal of waste manganese steel screen
This development process seems to be simple, which easily leads to some problems. Some replacement workers lack the basic social theoretical knowledge. After loosening the bolt of the fixed screen, they use the machine to pull it out. It is necessary to know that there must be a set of management standard application program for taking out and placing, otherwise the service life of high-quality manganese steel screen will be shorter. The standard operation procedure is: loosen the fastening bolt of the screen first, do not take out the nut completely, and rotate the fastening bolt for 90 minutes ° , Pull it out of the long hole of the manganese steel screen hook plate, then take out the manganese steel screen hook plate, take out the screen, and then pull it out.
3. Standard installation
After the manganese steel screen to be replaced is put into the screen bracket, the screen shall be fixed and tightened. When tightening the manganese steel screen, the left hook plate shall be in a vertical position, the right hook plate shall be tightened, and then the left bolt shall be tightened. During the screening process, the manganese steel screen and the screen frame shall vibrate synchronously, In order to ensure that enterprises can not be separated from society.
It must be noted that there is a 2mm thick tension plate at the bottom of the pre tensioned manganese steel screen, and the tension force should be as large as possible during the tension process, so that the distance between the spring wires can be 0.5 ~ 1.0 mm.
4. Vibration pads must be installed at the bottom
The main influence mode of the vibration foot pad is to protect the upper manganese steel screen and slow down the impact of screening materials on the screen surface of manganese steel screen and the impact between the screen surface and the screen frame below. According to the development observation for many years, it is found that polyurethane strips play a greater role in damping than ordinary rubber strips, and can be used for a longer period of time, which can effectively protect the screen surface of manganese steel screen, It is suggested that we have the conditions to choose polyurethane strips in the process of use as far as possible.

CATEGORIES

CONTACT US

Contact: Mr Zhao

Phone: 13156833688

Tel: +86-543-5650226

Email:

Add: Huji Town Toll Station in Huimin County, Shandong Province, 200 meters south

Scan the qr codeClose
the qr code